CMC, ML-10 Manual Power-Lift, 10'' Setback Transom Jack Plate

CMC, ML-10 Manual Power-Lift, 10'' Setback Transom Jack Plate

Manual Features:

• One Piece Design
• Made of 6061 T6 extruded aluminum alloy
• Stainless steel fasteners for maximum strength and durability
• Centrally located adjustment screw for positive alignment
• 10" Set Back from Transom
• 5" Vertical Adjustment
• Rated up to 300HP V-6
• This manual transom jack plate outboard lift can be operated from top or bottom
• Designed to fit standard B.I.A. bolt pattern without drill holes or making modifications in the boat or motor
• Available in 5.5'' and 10'' Setback

---

The 61012 Manual Jack plate for outboard motors a best seller. It will set the motor back away from the transom 5 1/2 inchs which will get your prop away from the boat in what is called "cleaner water". There is less water turbulence 5.5" farther aft than at your boat transom and the water goes under your transom, then sweeps up toward your prop. This will allow you to raise your motor on the average of 3" higher than you can at your transom and still have water pressure and a good "bite" with your prop. Also, the 5.5" set-back provides leverage to get the bow of you boat up with less trim allowing you to lift your motor higher. Less boat in the water and less engine lower unit in the water equals more top end speed, better fuel economy and more prop clearance in shallow water.

---

(click an image below to enlarge and view)

                                                                

---

Those who bought the PT-35 also purchased